Sink And Hob Aperture Jig

Sink and Hob Aperture Jig will enable you quickly and neatly, rout recesses and apertures in worktops to fit a range of sinks and hobs

Use with a 12.7mm diameter x 50mm Tungsten Carbide Router Cutter.
The jig has four sets of radius curves, left and right hand at 100, 80, 60 & 40mm radii.
Left and Right hand 90° Angles and a central slot that will enable you to cut straight cuts up to 480mm long.
Each set of radius curves is paired with a set of peg holes that will set the jig at 50mm from the edge of the worktop.

Back...